Assemble six colour coded fibre glass poles and separate according to size i.e. 3x large poles and 3x small poles.

Unroll flysheet and ensure all zips are closed.

Feed the three large colour coded poles through their sleeves diagonally from corner to corner. Follow colour coding. See Figure 2.

Fit rain cap to the centre of the tent. (Before erecting)

Insert “key pieces” attached to the key rings, see Figure 1, to the ferrules at one end of the large pole, push opposite end of the pole through the sleeve and insert the end into the corresponding key piece. If possible do this for the three large poles simultaneously i.e. one person per pole. Otherwise push one pole through at a time.

Feed the remaining three small colour coded poles through their corresponding sleeves.

Insert “key pieces” attached to the key rings, see Figure 1, to the ferrules at one end of the small pole, push opposite end of the pole through the sleeve and insert the end into the corresponding key piece. Repeat this for the three small poles to erect the bedroom compartments.

Attach clips where fitted, see Figure 3.

Peg flysheet to give tent stability also peg guy ropes, peg the bedroom compartments tightly away from inner tents (to avoid leaking).

Unroll inner tents (bedrooms) inside flysheet and peg four corners. (Ensure door is facing outwards!) 2x large inner tents and 1x small inner tent: small inner tent is fitted to the rear and the two larger inner tents are fitted on each side.

Lay out fitted ground sheet and peg through the eyelets provided.

Use steel uprights for canopy in fine weather only and never leave unattended.